DR - Testing Image Capture in Planmeca

Testing the capture of images with a Planmeca device

  1. Typically, a client will expose the image once they see the green light on the control box, by pressing the Capture button.  
  2. It can take, approximately 2 seconds for the successful capture message to show up, after you press the capture button. The successful capture message will show in the Planmeca Console log.
  3. The image will show, after approximately 5 seconds. 


Successful Capture message example: 

Fri 2016.08.19 10:23:08 TRACE        - PMC: PMC_IMAGING_STATE_EXP/XFER    (PmPmc.cpp:4922)


Was this article helpful?
0 out of 0 found this helpful